词语站>英语词典>deflections翻译和用法

deflections

英 [dɪˈflɛkʃənz]

n.  (尤指击中某物后)突然转向,偏斜,偏离
deflection的复数

柯林斯词典

  • N-VAR 偏斜;偏转
    Thedeflectionof something means making it change direction.
    1. ...the deflection of light as it passes through the slits in the grating.
      光线通过光栅狭缝时的偏转
  • (体育运动中球击中某物后的)转向,变向
    In sport, thedeflectionof a ball, kick, or shot is when the ball hits an object and then travels in a different direction.

    双语例句

    • Analysis to Large Deflections of Elastic Cantilever Beam with Constraint under Uniformly Distributed Load
      均布载荷下变形受约束悬臂梁弹性大变形分析
    • Where required, to examine deflections, stiffness requirements, and any special material and design provisions to obviate brittle fracture under adverse conditions.
      必要时验算挠度、刚度要求、以及任一特殊材料和设计规定,以预防不利条件下的脆断。
    • The effects of deflections are evaluated during the process of calibrating the balance.
      变形影响是在天平校准的过程中测量的。
    • However, while some building codes provide methods for estimating shear wall deflections, these methods are not adequate for shear walls without hold-downs.
      尽管有些国家的建筑规范中已给出了估算木结构剪力墙侧向变形的方法,但这些方法并不适用于无抗倾覆锚固件木结构剪力墙。
    • The pace analyzes the current pre-arched calculation and installation method based on the relative deflections, and proposes a new absolute deflection method.
      本文在对现行的基于相对挠度的预拱度计算设置方法进行分析后,进而提出了新的绝对挠度法。
    • The deflections of throttle slices were analyzed and the equivalent relations of flux distribution were deduced according to the structure of self-designed hydro-pneumatic spring.
      根据自主研发阻尼可调油气弹簧的结构形式,分析了叠加节流阀片的挠曲变形量,给出系统流量分配的等效关系。
    • The deflections of the blades under different wind speeds and different rotating time were given to validate the reliability of the model presented herein.
      研究结果对风力机叶片的振动特性和疲劳寿命预测以及高性能叶片的设计有理论指导意义。
    • They observed the deflections of the particles by allowing them to fall on a fluorescent screen.
      他们让粒子落在荧光屏上以观察他们的偏移。
    • But, more significantly, the overturning moment and the shear deflections produced by lateral forces are much larger and must be carefully provided for.
      更重要的是侧向里所产生的倾覆力矩和剪力变形要大的多,必要谨慎设计来保证。
    • Equations are established based on the principle of deflections consistency.
      根据板簧变形协调原理,导出相应的方程。